DTA019 xx

[TommyT1]

According to the manual, it states only "Frame alignment maintenance limit".

We've been having problems with people dialing out getting cut-off, getting recordings here the last week or so. What I need to know is if this alignment limit message has to do with the PBX or with telco (as in the T-1 taking hits).

Any help would be greatly appreciated!

- Tommy

 

[Reusser]

The answer is both.

The problem is one of the two has a clocking problem - could be at either end.

To test your clock
LD 60
SSCK 0

You should get info showing clock locked to loop x (depending on you switch type)
If clock is freeRun - use this command

TRCK PCK

Post back what you get with SSCK

 

[jackdaniels1955]

LCNT (loop number) is another good command, helps you asess what may be wrong. How many clock controllers have you set up? and/or what switch are you talking about?