DTA errors

[Terry6868]

I would like to know is there anything I can do or is it my telco provider issue.

I am getting
DTA203 0 0, 1, 2
DTA201 0 0, 1, 2
DTA204 0 0, 1, 2
errors

I am thinking it is a far end alignment issue in LD 60 when I do a lcnt the RAI counter was over 2,000 on each one of these loops which I believe is remote alarm indication.

 

[KCFLHRC]

Check your clocking in LD 60 and see if it's tracking on Primary

 

[KCFLHRC]

DTA0203 loop x y A Group 2 error has been detected by the PRI2 card. The error information is
decoded as follows, where x : 4 = LOS (loss of signal) 3 = AIS (alarm indication
signal)2 = LFAS (loss of frame)1 = LMAS (loss of CRC multiframe)0 = RAI
(remote alarm indication) Where y: 2 = alarm occurred1 = alarm persisted 0 =
alarm clearedExample: DTA203 7 4 2 - PRI loop 7 loss of signal occurred.
Action:
Severity: Minor. Critical to Monitor: Yes. SNMP trap: Yes

DTA0204 loop e Incomplete or incorrect ANI was received by CDTI2/CSDTI2 FW (outgoing
trunk) which reports this fact to the main CPU by SSD messin 9 (NI problem
report).
Action: This is a "warning only" message. No additional actions are taken. The
call will be processed regularly. However, FW will use the special hardcoded in
FW value as ANI.
Severity: Minor. Critical to Monitor: Yes. SNMP trap: Yes

DTA0201 loop The Carrier Interface (CI-1) firmware has initialized.
Action:
Severity: Minor. Critical to Monitor: No. SNMP trap: Yes

 

[Terry6868]

Thank you KCFLHRC for reminding me about the clocking. I checked the clocks and found 1 in DTI061 and issued the tracking command to get that back to locked to slot 1 but, I'm still receiving the DTA203 201 0 0, DTA203 204 0 1 DTA203 203 0 2 errors with RAI errors still going up.

 

[Terry6868]

The error has now changed to DTA203 3 0 an AIS alarm.

 

[Terry6868]

now back to the original DTA203 errors for each loop...going to say I've done all I can in the PBX and it's a telco issue.