DT570

[harddisk15]

Can DT570 handsets be used with Cordless system manager DCT1800 with software CAHNB 20103/1 R6a , LZYNB 20101 R6a. The handsets we use DT360 are no longer available.
Cheers

 

[kings1]

Harddisk15,

You need the programming set NTM/DPYNB 101 23/1 for programming the DT570 handset with CSM.

Which protocol is your DCT1800 system? GAP or A/B.

Kings

 

[harddisk15]

The protocol is A/B. I'm not having much success.

Cheers

 

[soaplover]

Procedure:


handset
Press "1" ," 4" and "ON" simultaniusly
INIT GAP shows
Change init method to A/B by pressing "NO"
Init A/B shown in display
Connect the cable (important do the init before connecting cable)
Program the handset
After programming ,remove the battery
Replace the battery ,and turn the handset on.

This should do it

//Soaplover

 

[hughiepal]

Hi Soaplover - That did the trick -- Thanks a lot.

Cheers

 

[soaplover]

Good ,not sure if they have fixed the firmware
that you have to remove battery .It was like this with some R2X version .Newest 570's are in R3X .