dss flashing

[kurn14d1]

Hello all,

I'm a new user to tda100d, and use the phone kx-dt333, I have a question about the kx-dt333.
1. Why not blinking lamp dss the incoming call? The lights were only turns red on (not blinking), How to setting up?
2. I used 2 pabx, when using tdn1232, to access to the pabx nec I used 88, but now have 808.How do I reduce the number of digit, so that it becomes shorter? can I use tie line?
I'm using extension 3 digits which consisted of 1xx and 2xx (on TDA100D) and 1xxx,2xxx(on NEC). and CO 14-17 to nec.

Thx

 

[cwc3]

is your ip phone part of a ringing icd group if not add it to icd group !! you can change feature access codes in numbering plan are of maint software

http://www.thetelephonemanonline.com

 

[cwc3]

you could have a GROUP 8 button on your phone

http://www.thetelephonemanonline.com

 

[obtsystems]

You can only change the 8 on line access, the 01,02 ...08 are group.
You could set private network with 1,2 as lead numbers and set trunk group to 8

you can dial 7 and extension number and it should pick trunk group 8 and dial extension on NEC

 

[kurn14d1]

Thank you obtsystems is working now. but the lights indicator are not blinking dss in dt333 flickering, what should I setting? The color is red, not blink.

 

[obtsystems]

what is not blinking on the dss, the co line or the extension dss?

if you have incoming call ringing on other phones and want it to flash on all other phones, then like CWC3 said, make sure all extensions are in ring group and set ring delay to no ring.

 

[kurn14d1]

I'm using KX-DT333, in this unit there are 24 lamp indicator for incoming calls. When I use pabx tdn1232, the light indicator for incoming call on key phone (KXT 7433) is red and blinking and no ring on the KXT 7433, but another phone is ringing. My question is can i to set the same with tdn1232? no ringer, but the lamp indicator is blinking for incoming call and then i pickup incoming call for another extension.

Sorry all, my english not good.

 

[obtsystems]

Is the other phone ringing using direct dial number
Or do you want to answer general calls on non ringing phones

 

[kurn14d1]

Yes, I want to answer general calls on the KX-DT333 with no ringing.

 

[obtsystems]

It has being posted twice on this thread what to do

Last time

You have to enter all extensions in incoming call group ie 601 and make the extensions in the group ring/ delay 2,3,4,5,6 rings or no ring in member table
Make sure the Ddi or dil incoming call lines are pointed to the group ie 601

 

[kurn14d1]

Ok, I already understand that you mean, thanks