DS3 Module not recognized in 3640

[icvanstra]

When installing an ATM 1A-T3 module into a 3640 Router I get the following error:

MEMINIT: No iomem table entry for pa type 0x1AA in slot 3

-----------

Bootstrap Version: 11.1(20)AA2
IOS Version: C3640-IS-M v12.1(3)
Memory: 64Mb

The module is not seen via sho inter or sho contr

-----------

I've checked that the IOS is new enough (just barely - 12.1(2) is required) but I don't know if the BootStrap is too old.

Any ideas on why this would be happening?

thanks,
eric

 

[icvanstra]

d

 

[Jynxx]

If you are absolutely certain that you have the proper version (I would open a TAC case just to make sure), you may have to issue a command to tell the router what kind of card it is.

I have a standard E3/T3 card in my 3745 and I had to issue the following command in config mode:

card type t3

Not certain on the ATM though.

 

[Frank704]

I have a 3640 and I'm also trying to install a E3/T3 card and it does not recognize it. Do you know the command I would use for the 3640, becuase I tried using that command and it didn't work.

thanks,

 

[icvanstra]

Frank704 - don't know on this one. We eventually installed it into different hardware (non cisco).

later,
eric