Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
DS-30 LOOPS 2
- Thread starter beybros
- Start date
-
1
- #2
The BCM 200 and 400 have the same amount of DS30 loops 8.
1 and 8 for the system
2-7 for Media bay modules.
This is correct providing the system is 2/6 split.
If the system is 3/5 split
1,7 and 8 for the system
2-6 for the media bay modules.
Marshall
1 and 8 for the system
2-7 for Media bay modules.
This is correct providing the system is 2/6 split.
If the system is 3/5 split
1,7 and 8 for the system
2-6 for the media bay modules.
Marshall
- Thread starter
- #3
2/6 split is as explained above.
On my website under downloads there is a basic course have a look might shed some light.
You will need to register to access downloads.
Marshall
On my website under downloads there is a basic course have a look might shed some light.
You will need to register to access downloads.
Marshall
-
1
- #5
when you need more media bay modules use 2/6 split = 6 DS30 buses
when you need more dsp resources (IP phones, trunks etc) use 3/5 split = 5 DS30 buses
to put it simply - hope this helps.
for a detailed introduction to bcm look at mrmarshall's wonderful training material
when you need more dsp resources (IP phones, trunks etc) use 3/5 split = 5 DS30 buses
to put it simply - hope this helps.
for a detailed introduction to bcm look at mrmarshall's wonderful training material
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question