Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drill down in powerplay 1

Status
Not open for further replies.

worldofchandran

Technical User
Mar 16, 2007
15
US
Hi,
I have a question on if we can drill down from one cube to another cube in Cognos Powerplay?
Can anyone help me out onthe steps involved in doing this stuff?
 
see the enterprise server guide. described step -by - step

christenhusz
 
You only need to setup Enterprise Server if you are using Enterprise Server to deliver your cubes, and even if you are you are only allowing drill through to other cubes to be possible for a cube or the entire server. If you are looking to drill through to another cube you must set this up inside of the Transformer model. You can do this either at the cube level or for individual measures. In a measure or cube inside of Transformer there is a tab to add drill through to a cube. If you are using Enterprise Server, the physical location of the cube is not important, just the cube name, so any location will do.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top