I have a problem with DRGs. When I call the extensions from PBX (MX-One) everything works fine, calls to private network (MD110) works fine too. But when I call longer numbers (for example public numbers) I hear nothing on analogue phones, and after 20-25 seconds I hear the busy tone. From other IP extension everything works fine (DBC 4425,4422). The extensions registered in DRG is in the same csp like 4425 or 4422 phones, so I don't understand where is the problem, or how to set DRG? I have tried to change dialtimeout, but it's the same.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
DRG22i problem
- Thread starter SpitItOut
- Start date
- Thread starter
- #2
I found some else about this problem... I have connected MX-One to public network through MD-110. When I call to public lines from IP extension (4425) everything is ok, but from analog phone through DRG22i, when I try command SUSIP on MD110 on route connected to MX-One, there is a traffic state REGISTER, but call is not forwarded to route connected to public network. This appears only for calls through DRGs.
Is there anyone who understand this?
Maybe the Skynet from Terminator?
Is there anyone who understand this?
Maybe the Skynet from Terminator?
- Status
Similar threads
