Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DPT - no boot device after adding new disks

Status
Not open for further replies.
tlapczyn

tlapczyn

IS-IT--Management
Oct 28, 2001
5
0
0
PL
Hi
I would like to ask you for help.
I have a RAID-5 build on three disk (ID=3/5/10).
When I add another two disk to the RAID controller and start the server, I have a responce "no boot device".
The new disk are accessible through ID=0 and ID=1.
Is it because after the disk adding the system tries to boot from device having the lowest ID?
In this case ID=0 - new disk?
When I remove these disks, I can boot from my array again.
Please help
 
Status
Not open for further replies.

Similar threads

rightmirem
  • Locked
  • Question
Supermicro SMC2208 not recognizing replacement OS drive
Replies
0
Views
211
rightmirem
rightmirem
maybeimaleo
  • Locked
  • Question
Is There A Calculation For Number of SSD Disk Per FC Disks?
Replies
0
Views
59
maybeimaleo
maybeimaleo
winsys20
  • Locked
  • Question
LSI MegaRAID SAS 9260-4i beeping, Server will not boot into OS now
Replies
1
Views
126
technome
technome
goombawaho
  • Locked
  • Question
Recommendation - NAS device with remote access
Replies
4
Views
99
goombawaho
goombawaho
vintagedon
  • Locked
  • Question
Event ID 129: Reset to device, \Device\RaidPort1, MegaSAS (RAID 84016E) 1
Replies
12
Views
386
technome
technome

Part and Inventory Search

Sponsor

Back
Top