Thanks in advanced. I am working with a couple of Polycom vtc equipment and are having trouble with calling ISDN. The calls are routed through a Avaya G3siV11. I can call out and in using the ISDN phone option on the polycom but when I call an outside vtc unit it keeps downspeeding and eventually drops off. The same happens when they try to call me if it even goes through. Any suggestions on what I should test. About the only thing I have is butt set to test the line and I do hear a click every 14 seconds.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Downspeeding while in call
- Thread starter ARCOER
- Start date
PeterHurst
IS-IT--Management
The click sounds od - if it's interrupting the data stream it could be causing errors and making the VC drop the call.
First bet would be to have the telco test the line, then if you can run an error check over each ISDN with a tester.
First bet would be to have the telco test the line, then if you can run an error check over each ISDN with a tester.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
