I have converte one of my old 840 phasers to an 850 board and chip. it prints fine, lovely colour and piccys, but two faults remain.
one is it will not double sided print, despite it being selected on the menu. I thought they were all capable of double sided printing p providing the 850 board chip was installed.
the second issue is no matter what , apart from using the single sheet feeder, can i get the printer to print from the lower tray.
the paper always enters the shiny metal slot prior to the drum (its where you feed the card when you have a jam) and then stops with a jam error, any ideas on a fix.
regs
Mart
one is it will not double sided print, despite it being selected on the menu. I thought they were all capable of double sided printing p providing the 850 board chip was installed.
the second issue is no matter what , apart from using the single sheet feeder, can i get the printer to print from the lower tray.
the paper always enters the shiny metal slot prior to the drum (its where you feed the card when you have a jam) and then stops with a jam error, any ideas on a fix.
regs
Mart