Door phone does not release 1

[tyronejr]

Hi all,

I have an IPO on 9.1.6 and has 3 phone 30s. On the 3rd module I have 6 siedle door phones. I have changed the ports to IVR. All works. They ring I can enter the door open code. When I hanger up the phone the 800ms disconnect happens. But in system status I see the door phone pick up the extn for the next 30 seconds. The door phone has to have its conversation timer to expire before I can use it again. Is there a way to send a busy tone to the port instead of a disconnect rather than loss of voltage?

Thanks

 

[derfloh]

I never programmed ports for Siedle door phone analogue to IVR. Never had any problems leaving it as "telephone".

 

[budbyrd]

Never done it with that brand of phone. IVR is used to stop the far end from receiving a disconnect tone if the door phone remains off hook. Is there a way to shorten the disconnect timer Siedle?? The IPO by default should be expecting a 500ms. Otherwise you would have to change to a trunk port to use tone disconnect.

Dermis and feline can be divorced by manifold methods.*
*(Disclaimer for all advise given)--'Version Dependent'

 

[intrigrant]

Do not set the ports to IVR, just default analog station will give busy tone, IVR port does not.
You can program the siedle that if a command is given to open the door it automatic disconnect the conversation and immediate ready for the next call.
When not open the door there is a command (#0??) to immediate disconnect.
Read the manual and try to understand it, it is a german product and documentation is crap to read and understand.