Does ProComm go up to 921K?

[aaiqbal]

Hey Everyone,
I was wondering if ProComm goes up to 921 K. Currently, it seems to only go up to 115200 Baud Rate.
If it does go higher, can I just do it in the setup in the set port baudrate command?

 

[hankm3]

Hello,

The Help File states that setting the Baud Rate is the speed inwhich Procomm "Talks" to the Modem. So it seems to me that if your Modem is set to 921K then Procomm should work at that speed also. I don't have a connection speed that is that high, so I can't say for sure.

Have you tried to use Procomm using Cable or ADSL as a Test ?

Hank

 

[knob]

The max default port speed that Procomm will accept is 115200. There is an INI entry you can make to replace the 110 value with a value of your choice. However, I am not sure if it handles values about 115200 or not. Here is a snippet from my site:

If you need to communicate at a baud rate not supported by Procomm Plus, you can add the BaudRate INI entry under the [Options] section. The value assigned to this INI entry will replace the 110 baud rate in Procomm Plus. I have not tested this INI entry, other than verifying that the 110 baud rate value in the Quick Select Line is indeed changed to the value I specified in the INI file. This INI entry is valid for version 3.0 of Procomm Plus and higher.

aspect@aspectscripting.com

http://www.aspectscripting.com