Does anyone know how many T1 (PRI)c

[hawks]

Does anyone know how many T1 (PRI)circuits I can put on the Option 11 C? Can you put any in the expansion cab? I have heard both you can and you can not is anyone doing it if so have you run into any problems.

 

[M1eng]

What rls are you running?

Main Cabinet;
I'm pretty sure for Rls23 and up you could fill the whole main cab with PRI's (slot 1 - 10, not mmail slots). Just make sure you keep the clock controller on a card in slot 1 - 3.

Copper and Fibre Expansion Cabs;
No chance!

IP Expansion Cabs;
Just as in the main cab, you'll also need a clock controller in this cabinet as well.

 

[DDionne]

M1, I think it's slots 1 - 9 in the main cabinet but not slot 10. As for the expansion cabinets, i have not had the opportunity yet but i heard it was possible in the first 9 slots.


DD

 

[hawks]

We are running RLS 25

 

[hawks]

From the RLS 25 books has anyone tried it?
Insert the NTRB21 TMDI circuit card into card slot 1-9 in the Main cabinet, or in slots 11-19, 21-29, 31-39, 41-49 of the first, second, third, and fourth Expansion cabinets, respectively.

Insert the NTAK09 circuit card into slots 1-9 in the Main cabinet, or in slots 11-19, 21-29, 31-39, 41-49 of the first, second, third, and fourth IP Expansion cabinets, respectively.

 

[Draxis]

As far as I know, you can only use T1 cards in expansion cabinets if you have the IP Connectivity package, and if the cabinets are IP Expansion Cabinets. It won't work in expansion cabinets if they are connected via fiber.