DockForm not found using Delphi XE8

[Kenbla]

Hello, I work with an upgrade from an old Delphi version to the newest XE8 and run into problems when I try to compile the application. I get an errormessage in the Embarcadero file ToolsAPI.pas saying "ToolsAPI.pas(18): F2613 Unit 'DockForm' not found". I have searched on the Internet and found several suggestions, but most of the suggestions were targeted for other Delphi versions! One of the suggestions was to add designide.dcp as a Runtime package which I have tried (see the attached file), I still get the same errormessage though.
I would appreciate any assistance in this matter.
Regards,
Kenbla

 

[whosrdaddy]

can you give a bit more info?
From what Delphi version are you upgrading and what component are you trying to port?
If you come from a version lower than D6, then chances are big that your package includes designtime and runtime code which needs to be separated now.
Please post the .dpk code and then we'll see...

/Daddy

-----------------------------------------------------
Helping people is my job...