Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Do I use BARS?

Status
Not open for further replies.

M1north

IS-IT--Management
Sep 28, 2007
357
CA
Hello Tek-tips,

I`m looking to purchase a used 81C. IT has NARS but it doesn't have BARS. I looked into my system, and I`m setup as follows for call routing:

Area codes are set to RLI which are then in LD 86 to choose RLB

EX: 1212 (LD) = RL1 4 212 (local) uses RLI 1. Each RLI has entry 0 + 1 for multiple routes/T1.

Also, I have multiple T1/PRI on this 81c tying into other PBX on different RLI that traverse accross different routes.

I`m not a big NARS/BARS guy so need to know.

Thx!
 
If you are using RLI's then you are using BARS. I would find it hard to believe that a switch is licensed for NARS but not BARS. Guess it depends on how old it is.
 
I am with KCFLHRC, it would be strange to me to see a switch with NARS without BARS... In your switch post your LD 86 print out of your ESN.

REQ prt
CUST 0
FEAT esn

Do you have anything listed for AC1 or AC2?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top