I have a DNA 4.0 Server connected to a BC11 MD110 through the network. Whenever i make a change to NIU on the node setup parameters,it is not saved. Rather it defaults back to the IPU settings and i therefore cannot connect to the PBX from the DNA Server. Pls what could be wrong?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
DNA Connection problem
- Thread starter EchoSpark
- Start date
Hi,
The node setup dialog is not what it should be, it default back to certain values every time you close it. This however does not mean that your configuration is not saved.
If you are changeing the ip address do not forget to go to communications setup and add it to the list of IP addresses used to connect.
/mk
The node setup dialog is not what it should be, it default back to certain values every time you close it. This however does not mean that your configuration is not saved.
If you are changeing the ip address do not forget to go to communications setup and add it to the list of IP addresses used to connect.
/mk
- Thread starter
- #3
Thanks i just realised that, but i have another question. Should the ethernet port on the NIU be configured as Network/OUT or Network/MML?
Presently,i have configured the ethernet port as Network/OUT. To change this to Network/MML if need be, is command IOEQI also to be used on the same port configured as Network/OUT?
Presently,i have configured the ethernet port as Network/OUT. To change this to Network/MML if need be, is command IOEQI also to be used on the same port configured as Network/OUT?
gcdhnjgfhfgsxh
Technical User
DNA4.0 MD110 support isnt designed for BC11 - upgrade to DNA 5.0/5.1/5.2
dave
dave
- Status
Similar threads