DMZ LAB Question?

[XMTS]

I hope this question does not offend anyone as I am no expert in Cisco PIX firewalls by any means. However, in a lab environment with the limited equipment that I have, I want to be able to setup my PIX 515 as a device which can route between three separate segments to the outside and between one another:

Example:

E0= Outside
E1= DMZ1 10.1.150.x
E2= DMZ2 10.1.151.x
E3= DMZ3 10.1.152.x

Is this possible? Being short of a layer three switch I bascially want all DMZ's to be able to route packets to one another and to the outside.

Any advice would be most appreciated.

Thanks in advance.

 

[baddos]

Yes it's possible depending on your access-lists.

-Bad Dos