DMID Operations

[tarheel25]

I relocated an Octel 250 approximately 30 feet this morning. I followed the procedure in sub menu 13 for powering down the Octel. We are doing the integration between the Octel 250 and a Nortel Option 11C through a DMID. After powering down and moving the DMID I have been unable to get the DMID to work properly. All connections from the Option 11C to the DMID are correct. The DMID light "A" continues to flash and any call forwarded to the Octel doesn't have any called party information sent with it. Does anyone have any suggestions?

 

[KenMeans]

the flashing a light tells me that the 2616 set is not active or the dmid cant see it try pluging in a 2616 set into the line cord going to a or stat it in the pbx and busy it out and rel's it

 

[KenMeans]

check the config note at this link

http://support.avaya.com/elmodocs2/Octel/config/cn5004.doc