Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dlink 614+ loses interface with traffic 1

Status
Not open for further replies.

dublklik

MIS
Oct 16, 2004
41
AU
I have a Dlink 614+ wireless router that loses wireless and ethernet connectivity if I have too much traffic (download etc). I can use it ok for simple browsing and am using it now to write this. I have the latest firmware and it was working well for a few weeks. It also takes ~3min + to start up, when I first turn on the power nothing happens and then slowly the lights come on. It used to be quick to power back up after a power off, now it takes a long time. Wireless seems to be the easiest to kill, I can make it happen just by viewing the web interface of the router, the ethernet seems ok for this.

Because it takes so long to start I am suspecting a power issue and will try a new adapter. Any other suggestions appreciated. Let me know if you need any more info.

Thanks,
 
Yup, I'd go with a replacement PSU. Had a very similar problem with a Dynamode Gigabyte switch, l.e.d's came up at a leisurely pace rather than boing! straight on. When I opened it up, the internal PSU capacitors were all bulging nicely! Replaced 'em with new ones, and it's been fine ever since...

ROGER - G0AOZ.
 
Thanks. ( I am asuming by PSU you mean the power adapter and not something internal on the router?)........ I know only slightly more than "dont put your finger in there!!" about electricity.
 
Yes, PSU = Power Supply Unit. A common term for the box of tricks which converts AC mains voltage down to the DC voltage(s) required to run bits of kit like your router, laptops, desktops, minitower PCs, etc. I can't of course guarantee that's the answer, but it sounds like it. Maybe get an electrician to check the voltage out from the PSU before you splash out on buying another one. The label attached to the unit will tell you it's output voltage (e.g. 12vdc), and then get him/her to check it under load. It should come up to full working voltage instantly, and not waiver around. Voltage probably ought not to be more than +/- 5 per cent.

Hope that helps.

ROGER - G0AOZ.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top