Distributed voicemail pro 7.0.28 in SCN loose connection to IPO 1

[sagbab]

Hi.

I don´t know if this is a 7.0.28 problem or a SCN problem. It seems like after upgrading to 7.0.28 and connecting it to SCN VMpro is acting strange. It seems like the Voicemail service stops without reason, and when started it cant connect to the IPO (0.0.0.0 at the top of the tree) When rebooting the server and restarting the service it seems to work again. At least for a while.
The SCN consist of two IPOs and two VMpro where this one is set to distributed and the other to centralized. Both VMpro is on the same virtual server with the same IP scoop. This IPO is on another scoop, but seems to work fine otherwise. Licenses valid. I don´t have access to the other IPO and VM so it would be preferable to still have two separate VMPros.

Any ideas?

 

[amriddle01]

A few people have this issue, seems to be a bug

http://www.ipoffice.tel

 

[amriddle01]

BTW it's a 7.0.28 issue as it also happens on single (non SCN) sites

http://www.ipoffice.tel

 

[sagbab]

Ok, thanks. You wouldn´t happen to know when the next release is due? Maybe better to downgrade?
And have a star for the quick reply.

 

[amriddle01]

The next release is a tricky one to determine as they are working on getting the 96x1 handsets working....but they can't. I am not so sure this would make it in though as it may not be an accepted bug yet, I know HSM has seen this but not sure if Avaya have recognised it

http://www.ipoffice.tel

 

[hairlessupportmonkey]

I have seen this too. started as soon as we went to .28. Spoke to Scansource and they havent had any reported issues. So nothing like being at the forefront of unknown issues.

I have debug view logging VM Pro at the moment. its been OK for the last 24hrs. Typical!

ACSS - SME
General Geek