BigDaddy21
Technical User
I am attempting to load an Ultra 60 box via an Exabyte 8mm Tape Drive The machine starts loading Super Blocks from the tape and then I receive the following messages: Warning: /pci@1f,4000/scsi@2(glm2): Disconnected Command Timeout for Target 6.0
Warning: /pci@1f,4000/scsi@2(sd216): Scsi Transport failed: reason timeout: retrying command
Warning: /pci@1f,4000/scsi@2/sd@6,0 (sd216): Error for Command: Read Error Level: Fatal Requested Block: xxxxx Error Block: xxxxx Vendor: Plextor Serial Number: xx/xx/xx xx: Sense Key: Unit Attention ASC: 0x29 (poweron,reset,or bus reset occured) ASCQ:0x0 FRU:0x0 Sense Key: Not Ready ASC:0x4 (LUN not ready) ASCQ:0x1 FRU:0x0
nNo Tape Found
Please insert a tape in the drive and press enter when the light stops blinking:
Upon hitting Enter I receive a Bus Core Dumped I have researched Sun's site as wellas some other forums and everything points to the onboard SCSI controller. However this motherboard and SCSI controller card have both been swapped with known good ones to no avail. If anyone has any info it would be appreciated.....
Warning: /pci@1f,4000/scsi@2(sd216): Scsi Transport failed: reason timeout: retrying command
Warning: /pci@1f,4000/scsi@2/sd@6,0 (sd216): Error for Command: Read Error Level: Fatal Requested Block: xxxxx Error Block: xxxxx Vendor: Plextor Serial Number: xx/xx/xx xx: Sense Key: Unit Attention ASC: 0x29 (poweron,reset,or bus reset occured) ASCQ:0x0 FRU:0x0 Sense Key: Not Ready ASC:0x4 (LUN not ready) ASCQ:0x1 FRU:0x0
nNo Tape Found
Please insert a tape in the drive and press enter when the light stops blinking:
Upon hitting Enter I receive a Bus Core Dumped I have researched Sun's site as wellas some other forums and everything points to the onboard SCSI controller. However this motherboard and SCSI controller card have both been swapped with known good ones to no avail. If anyone has any info it would be appreciated.....