Badphoneman
Technical User
Can you have disconnect supervision on a ata or asm8 on the Norstar?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Disconnect supervision 1
- Thread starter Badphoneman
- Start date
- Status
-
1
- #2
curlycord
Programmer
This is a line setting, not a device setting.
So yes to all.
But remember the Teloc needs to have the setting turned on also as well as programmed in the KSU.
=--(((((((((()--=
curlycord
So yes to all.
But remember the Teloc needs to have the setting turned on also as well as programmed in the KSU.
=--(((((((((()--=
curlycord
- Thread starter
- #3
Badphoneman
Technical User
Where under sets is the prompt to turn it on? I can find it for trunks but not analog sets? I'm a Opt. CS1000E guy so my Norstar is limited and has about 15 years of rust on it.
RikRodgers
Vendor
As curly is saying, it's enabled under lines for the CO's, but not for the extensions. You won't find it under Terminals&Sets.
curlycord
Programmer
- Status
Similar threads
