DISA to access paging

[pginhb]

I'm trying to set up DISA so a remote site can access paging at the main site, ACDN's do not work due to some trunk to trunk restriction (calls get bounced to 0) I have set up an analog port, CLS has MNL and FTR has hot d 2, then the 2 digit paging ACOD and when I call the DID it just rings no answer, have tracked it and it hits the port. Also tried the DISA but when I enter the paging ACOD I get a fast busy, also used the DISA and entered the analog port above with the Hot d and I tracked it, it hits the analog port but also rings no answer. Thanks

 

[bignose21]

what about a phantom?

 

[pginhb]

Tried that phantom, calls gets bounced to the operator.

 

[bignose21]

is it something in the Intercept treatments INT_DATA thats getting the call, we use phantoms to forward to MIRAN channels by forwarding to the ACOD so we can listen to newly added announcements remotely. Other option do you have a callpilot, a CP application would get round the intercept.

 

[kstaff22]

this may be a little drawn out for something as simple as paging----but it sounds like you are saying that the disa can;t use the ACOD of the page route due to trunk to trunk restrictions.----how about using cdp?
assign an unused number as the remote paging, program that number as a TSC (trunk steering code)---point it to an RLI that local terminates (LTER=YES)--build a dmi for that RLI that deletes what was dialed and inserts the ACOD of the paging.