DISA call doesnt show auth code in the CDR

[Supportvzla]

When I make a call using DISA, the CDR shows a trunk to trunk call and the number dialed, but not the authorization code I used. All other calls using auth code show the auth code in the cdr. I am not sure, but I think that this started to happen when I changed the auth codes from 4 to 6 digits.

supportvzla

 

[cmawbey]

Hello..If you print out your Authcode Data Block in LD 88 you will be able to see if the "Activate CDR for Authcodes" is set to yes or no. There is no default for this setting therefore a yes or no must have been entered when the original programming was entered. You may change this setting in the same overlay. Colin

 

[cmawbey]

Ld 88
req=chg
type=aub
cust=x
ACDR needs to be YES...(ACDR= activate CDR for authcodes)


try that
Colin

 

[Supportvzla]

Yes It is set to yes and all other calls using Auth codes show the auth code in the CDR.
I think that I probably have the answer to my problem: I just read that if the Incoming route has the CDR activated (CDR=yes) then I wont get any indication that it was a DISA call.

supportvzla