Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Director 8.5 with Embedded Flash 5 printing errors

Status
Not open for further replies.

ryans1000

Programmer
May 21, 2001
8
0
0
US
I have a crasing problem that occurs when using embedded flash 5 movies inside of a projector. Its directly related to printing. When I try to have the flash asset print itself, flash prints itself fine but if I exit that MIAW and reenter it again or any other window with another flash asset, I get a fatal error. It doens't happed every time, it is inconsitent. It also doesn't seem to happen with every printer. I have had a couple of comlaints with network printers, I have personally seen it happen with our network printer but never on any of the 4 local printers I tested with. The network printers that have had the problem are HP LaserJet 5000 and HP 4000.

Also if I print with Printomatic and than enter a page with a Flash Asset, i get the same problem. In authuring mode, everything works fine but its when I test the projector, I get the problems.

I would really appreciate some feedback on this because this is a largely distributed program and very big project. Here is the exact error I am getting.

FOODWISE caused an exception 10H in module FLASH ASSET.X32 at 018f:6a202fff.
Registers:
EAX=00003200 CS=018f EIP=6a202fff EFLGS=00010206
EBX=00000000 SS=0197 ESP=0062ea24 EBP=0137f00c
ECX=0137f00c DS=0197 ESI=01f7f00c FS=3d8f
EDX=ffc00000 ES=0197 EDI=00000001 GS=3d7e
Bytes at CS:EIP:
d9 45 50 d8 5d 04 8d 7d 50 df e0 9e 0f 85 0c 01
Stack dump:
00000001 0137f00c 0062ea4c 00000000 6a20264e 00000000 00000000 0137f00c 00000000 0037f00c 0062ea80 6a202aeb 00000000 00000000 00000000 01ce134c

this program has performed an illegal operation and will be shut down.

if the problem persists, contact the program vendor.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top