IPO Basic Partner r 8 Added 16 digital station module to the unit and have the following problem: 1416s plugged into the expansion module come up with a garbled display, the phones can make and receive calls and the display is fine when viewing the Menu options. Same 1416 plugged into the main unit work fine...any direction greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Digital Station Module Issue
- Thread starter Tom2129
- Start date
holdmusic34
Vendor
Shutdown ipo and unplug the power supply to control unit.
Give it 20 seconds and plug it back in again.
Are there any Nortel phones in this solution? IS this a DS16B? Nortel and Avaya should not be mixed on a DS16B.
Unplug all connections to the expansion unit and put them in one at a time. Check if the error persists with just one extension plugged in. One may have been plugged in to a PC.
Upgrade to a higher release within 8.1
8.1.95 may be suitable.
The Treasure Fleet is in the harbor!
Give it 20 seconds and plug it back in again.
Are there any Nortel phones in this solution? IS this a DS16B? Nortel and Avaya should not be mixed on a DS16B.
Unplug all connections to the expansion unit and put them in one at a time. Check if the error persists with just one extension plugged in. One may have been plugged in to a PC.
Upgrade to a higher release within 8.1
8.1.95 may be suitable.
The Treasure Fleet is in the harbor!
- Status
Similar threads
- Locked
- Question
- Locked
- Question