Digital phone high volume

[Sulev]

CS1000E, Rel 7.5 CPU-SS Cores, 4xOption 11C DC cabinets, MGS, MGCx3, Linux CPU, All digital M3280, M39xx phones have high volume - dialtone and talking.
Installed from default database, I changed all parameters, restarted MGS, MGC, conference loops, TDS , DTR Shelfs, loops, checked LD56 all parameters, LD 97, LD 17 also.
Analog phones are OK, IP phones are OK, problem with only digital (system) Phones.
MGS, MGC have all new loadware, firmware, CPU is patched with last paches. Linux base, NRS, em, SM, ... - all is pached and the everything works OK exept Digital phones!
Can you help me? I had this problem with previous PBX, too. Then I restarted Conf and TDS and made INIT and then everything is OK. Right now I don't understand how is it possible that analog phones have normal volume (dialtone also) and digital doesn't.
They use the same WCAD/FCAD values or not?
I restarted everything and disabled and enabled but...
I hope you can help me!
I know that it's better to have preconfigured database but here in Estonia I'm only one who can make this from default so I need to know what I made wrong.
Sorry if there is answer already in this threads but I can't find it.
With best regards
Meridian expert
from year 1994
Sulev

 

[PERRYPJ]

You can go to LD 17 and you can play with your ATRN,these only effect Digital sets.
SOLR is your side tone loudness
ROLR is your receive loudness
TOLR is your Transmit loudness
They are most likely set to default, I have had to change these on some systems because of squealing o some calls

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[Sulev]

Thank You
This helps!
Br
Sulev