Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations biv343 on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

DID Routing in Night Mode

Status
Not open for further replies.

countrytime

Vendor
Mar 30, 2007
204
US
Is there a way to set up a BCM 4.0 to route DID calls to an attendant at night instead of the set where the line normally appears? This would be like in a hospital where no calls are routed to patient rooms after a certain time.
I believe simple service modes will still allow the target line to ring on the assigned set as well as the night set.
 
I have it programmed in ringing service but when the service mode is on, both the dialed and night extension will ring. Any way to stop the dialed set from ringing short of using DND?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top