DID List ?

[bristolxyz]

I'm using the Dterm Series i phones on an NEC NEAX 2000 IPS system. Matworks Version 8.0.1


I have about 150 ststions on my system. I have an incomplete list of DIDs/Extensions, but would like an updated list. It there a way to get a list/prinout of all extensions with matching DID's?

Best regards,

Bristol

CTO
MSCE, CCNA, Novell, Symantec SS

 

[jhenke]

You will have to do a little leg work to get your list up. You will first have to listup cmd 7600, that will give the assigned DID's a three digit conversion block, then you will have to listup 7601 to see what extension the conversion blocks are assigned to.

Basically you are entering the DID's to get a code, then you take the code and see which extension the DID is assigned to.

You can talk about us, but you can't talk without us.

http://www.bbns-va.com/

 

[OzzieGeorge]

That is of course if digit conversion is used. First check 3518 to see if digit conversion is used then if it is check 3512 to see how many digits you are looking at (don't forget 0=1 1=2 etc) then check 7600 if that applies.

Otherwise it is possible your extn numbers match your indials in which case it is easier to just use matworx to do a len listup. This will list both physical and virtuals and that will give you all you need.

 

[jhenke]

good point OzzieGeorge jumping to conclusions on conversion

You can talk about us, but you can't talk without us.

http://www.bbns-va.com/

 

[pave35]

You can use CM 7699 to see only DID's (in or outside your range)that are converted in the order they were assigned.