DID instruction

[norstar655]

Hello All,

I just wonder if someone has a instruction or procedure on programming DID with Norstar ICS plus .

Thank you in advance.

 

[Dmacnumberfour]

norstar655,
This is how to setup a target line.
Target Lines Programming:
From Lines – Show
Show LN: 145 – Show (target line numbering differs depending on your software
1.0 sw – Lines number 121-312
R1T1 – Lines number 121-248
1.1 – Lines number 121-248 or 312 XC sw
2.0 to 5.0 – Lines number 145-272 or 336 XC sw
6.0 – Lines number 157-284 or 348 XC sw
Target LN – Next
Private to: (extension number) – Next
Rec’d #: (enter extension #) – Next
If Busy: to prime – Next
PrimeSet: 221 change to the extension # - Next
CLID Set: None – Next
Aux. Ringer: N – Next

Dmac,
End of list