DID followed by outbound call

[DevPlan]

I try to setup the following:

Someone calls in on a specific (either an ISDN30 or analogue) line and gets a new dial-tone where he can call out again using a trunk of that MD110.

The purpose is the following: I can make outbound calls with use of authorization code and by that, the calls get charged from my account and that works fine.

Now, lets say, I want to dial-in (when I am in another building) and make a new outbound call with using my authorization code.

Is this doable and how would I configure this?

I have BC10.

rgds, devplan

 

[DevPlan]

Isn't there any ///-pro who can answer me above (or below) questions?

I try to setup the following:

Someone calls in on a specific (either an ISDN30 or analogue) line and gets a new dial-tone where he can call out again using a trunk of that MD110.

I.e: I can make outbound calls with use of authorization code and by that, the calls get charged from my account and that works fine.

Now, lets say, I want to dial-in (when I am in another building) and make a new outbound call with using my authorization code.

Is this doable and how would I configure this?

I have BC10.
rgds, devplan

 

[cv8devil]

You can utilise DISA to st this up, although you do require the license for it.

 

[nschreuder]

It seems to me you're talking about Mobiel Extension.
But you do require licences for that too.




***************************************

“Science may never come up with a better
communication system than the coffee break.”

 

[new2md]

And the Auth code should be roaming