DID/DOD dialing and extension matching

[voipneerd]

Hi All
I've customer with CUCM ver 11. The customer have sip trunks with DID/DOD facilities. Unfortunately, I can't match the range with extensions number.
I've added a translation pattern for each DID and its extensions.
But don't know where to configure the DOD for each extension. So that all extensions will go out from specific DOD number

BR

 

[gnrslash4life]

I am assuming by DOD you mean outbound caller ID. If so, there are a couple of ways. YOu can either put it on the external mask of each phone. Or use the RL Detail info. Depending on your setup 1 is probably better than the other. But both will get the job done.

Certifications:
A+
Network+
CCENT
CCNA Voice
TVOICE
CAPPS