Dialing between two TDA 2

[Pujdo011]

I have TDA100 on site A, and TDA200 on site B. On site A extension numbering plan is 101-399, on site B extension numbering plan is from 401 to 500, both offices are connected with KXTDA0484.
Question is can(and how) I just dial 401, and avoid dialing trough access code for site B.

 

[cwc3]

yes sounds like time to start reading the book!!

 

[cwc3]

the acronym ARS comes to mind.

 

[shardian]

Use the TIE routing tables and don't assign a PBX code to each system.

Assign extension of each 'distant' system in the other PBX extension tables. Bit more to it, but thats the basics...

 

[Pujdo011]

As always thanks shardian
-------------------------

@cwc... I was expecting from you more, something like contact your vendor or something.
But I sure that you will write this next time, or something similar.

 

[cwc3]

hey you are clearly not a vendor so why should i read
the manual for you?or give the right info?

 

[cwc3]

shar you can help the uncertified tda users i'm done........

 

[shardian]

hardly helped.....pointed in the right direction. as i said, 'bit more to it' not like i actually told him exactly what to enter. also never even mentioned anything that may need to be changed in the 484...

 

[cwc3]

some where along the line he'll have to break down and read
the book frankly I'm suprised he got as far as he did