Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dialing AC1 blocked across PRI

Status
Not open for further replies.

motox2

Programmer
Jun 21, 2007
426
GY
I have a CME PBX tail hanging off a CS1000 7.6 system and when the tail PBX dials the AC1 (9) they are immediately presented with fast busy tone. I turned on DCH monitoring and I can see the 9 come across the DCH on the main CS1000 PBX. I checked the PRI route but cant figure out what is wrong. A work around I have discovered is to change the ACOD on the CS1000 route to "89" which allowed the CME to access the outbound PRI on the CS1000. I would much rather have the tail PBX dialing 9 as the CS1000 does to access the outbound trunks, but again I cant figure out what is wrong or if it can be done. Please advise Thank you
 
You need to find out what codes are accessible via AC1. I would download my revised conversion utility tool at
There should be a word doc guide to assist you.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website = linkedin
 
Hi Firebird, I don't think its an SPN,NPA,NXX issue as I get a fast busy as soon as I dial the AC1 "9".
 
Have you verified that the NCOS on your trunks connecting the two allow you to make the call?
 
NCOS has been checked, somebody mentioned it could be either the FTOP setting under the NET_DATA block, or the OVLR/OVLS setting on the DCH. Does this make sense?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top