Dial access to trunks

[skip0157]

I have a Merlin Legend system in key mode. It has 3 lines and the MLX10D phones have all lines indicated on the buttons. I have a few single line T/R sets on the system. If the user dials "9" it will connect to line 801. Is there a way to dial a codce on the T/R sets to get directly to lines 802,803, etc.?

If I add lines 802 etc to the T/R sets and line 801 is in use and they dial "9" it will pick up the other lines. However, I don't want this as the other lines are for a specific network.

 

[TouchToneTommy]

Key Mode

The factory-set ALS sequence for single-line telephones includes only ICOM buttons. You can
make outside calls by dialing the Idle Line Access code (usually 9).

Only assign the line(s) that you want the extension to use, set the ALS to Intercom and then the outside line(s).