Dial 0 for operator

[RohanAnd]

I appreciate any help you guys can give me. I have two extensions 8050 and 8051 that I would like to ring when an inhouse telephone calls 0. Thanks again for your help, this forum is great!

 

[RohanAnd]

I should of mentioned that it is a NEC 2000 IPS phone system using D Term Series I phones. Thanks!

 

[OzzieGeorge]

In cmd 200 set 0 to 801 (single digit extn)
In cmd 11 find a vacant Len and create extn 0.
In cmd 9000 find a key on the dterms you want to answer calls to 0 and assign 0 to the key!

 

[RohanAnd]

Thank you so much for your assistance, I was able to get the two phones to answer as I hoped. Step 2 was already performed (I found 0 setup in Command 11), so then I assigned 0 to a key on the phone and it worked. I remain confused about step 1 though. I didn't find 801 in command 200, nor did I add it. I have my command 200 data below. Do you mind explaining how to do what you intended in command 200? Thanks again so much!

A0 A146 Message Waiting/Message Reminder Search
A1 A004 Outgoing Trunk Queueing/Call Back Set
A2 A007 Camp-On by Station (Transfer method)
A3 A149 Message Reminder Cancel
A4 A006 Executive Right of Way (Executive Override)
A5 A010 Call Forwarding-All Calls Set
A6 A012 Call Forwarding-Don’t Answer (No Answer)/Busy Line Set
A7 A018 Call Forwarding-I’m here (Destination) Set
A8 A022 Do Not Disturb Set
A9 A040 MW Lamp Control Set
B0 A163 Voice Call/Ring Tone Programming
B1 A005 Outgoing Trunk Queueing/Call Back Cancel
B2 A125 Call Waiting (Camp-On by station-Call Waiting Method)
B3 NONE
B4 NONE
B5 A011 Call Forwarding-All Calls Cancel
B6 A013 Call Forwarding-Don’t Answer (No Answer)/
B7 A019 Busy Line Cancel Busy Line Cancel
B8 A023 Do Not Disturb/Return Message Schedule Cancel
B9 A041 MW Lamp Control Reset

 

[OzzieGeorge]

You have only listed the * (A) and # (B) settings in Cmd 200! try cmd 200 de 0 de and you should find it is set to 801 this assigns digit 0 as a single digit extension number. if you have three digit extension numbers, the first digit of your extension numbers will be set as 803 or if four digit 804!

There is more information here......

http://www.tek-tips.com/faqs.cfm?fid=6323

 

[RohanAnd]

Indeed it is. Thank you again for your assistance!