DGT call type

[andkas]

Hello,

I have my DGT setup as NPA to get the Calling NO to NUM_PLAN E164 TON National

How to get the Called NO NUM_PLAN to be Private?

Any help would be greatly appreciated
Andy



DMI 5
DEL 0
ISPN NO
INST 81
CTYP NPA


CALL REF # = 23
BEARER CAP = VOICE
HLC =
CALL STATE = 3 OUTGOING
CALLING NO = 6109872248 NUM_PLAN:E164 TON:NATIONAL ESN:NPA <---- Calling number is correct
CALLED NO = 816101234567 NUM_PLAN:E164 TON:NATIONAL ESN:NPA <--- Telco is stating that called number needs to be private

 

[KCFLHRC]

There is no private setting in the DMI, you could try UKWN or SPN

CTYP Call type to be used by the call. This call type must
be recognized by the NRS and far-end switch. This
is critical for correct CLID behavior.
If ISPN=NO, the CLID is based on this field. Is
ISPN=YES, the CLID is based on the call type
before digit manipulation.
pra-15
(NCHG) Call type not changed
INTL Special number in International format
NPA NPA
NXX NXX
LOC Location Code
CDP Coordinated Dialing Plan
SPN Special Number other than International
UKWN Unknown call type

 

[andkas]

Thanks for the update

I currently have the DMI setup as NPA, that sends the Calling and Called No as E164 National.
Telco wants to see the Calling Number as E164 and the Called Number as Private because I am sending 12 digits to route through their switch.