Detmine which Circuit A call hits

[OpethBWP]

So I have a route with 7 loops/circuits in it. By enabling Dch msging I can see inbound tfn calls hitting at least circuits in that route.

Is their anyway via ld 80 to see specifically which loops an inbound call is hitting?

 

[OpethBWP]

Actually the the bold part below from a DCH msg is the loop I think right..


DCH 11 UIPE_IMSG CC_SETUP_IND REF 00000500 CH 3 2

 

[bigindian65]

yes you are right loop 3 channel 2. you can call your desk as well, from your cell, or call any phone, go to ld 80 and trace it.


Mato' Was'aka

 

[trvlr1]

Stat your loops in LD 60, find a busy channel. Go to LD 80 enter:
TRAD xx yy Where xx is the T-1/PRI # and yy is the channel number on the circuit.
ie
TRAD 10 15
Check to see if that gets you what you need.