Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Determine where port is assigned 2

Status
Not open for further replies.

dhotep

Programmer
Jul 28, 2008
38
US

I have a Tn763B in a G3 v10 that has a port configured. How do I determine where this is in the software. I have checked "disp sys fea" and it is not the music on hold field.

I am looking to remove it. I see it physically goes nowhere.
 
\use display port xx x xx xx [ ie 01 c 12 11.]
List con all or list con carrier X will tell you what has assignations.

Display port will tell you waht is there, then you can use list usage (ext or whatever) xxxx for more detail...


Speak softly and carry a big switch
 
Code:
list configuration board 1c16

                              SYSTEM CONFIGURATION

Board                                                     Assigned Ports
Number   Board Type              Code     Vintage    u=unassigned t=tti p=psa

01C16    AUXILIARY TRUNK          TN763B  000004     01 02 u  04
--------------------------------------------------------------------------------
display port 1c1602
                                 PORT INFORMATION

                                     Port: 01C16002

                           Equipment Type: Paging
                           Identification:
--------------------------------------------------------------------------------
change paging loudspeaker                                       Page   1 of   1
                             LOUDSPEAKER PAGING

                                   CDR? y
            Voice Paging Timeout (sec): 30
           Code Calling Playing Cycles:

PAGING PORT ASSIGNMENTS
                 Voice Paging     Code Calling
 Zone  Port      TAC  COR  TN     TAC  COR  TN     Location:
   1: 01C1602    444  1    1                1      loud paging
--------------------------------------------------------------------------------
If tenant partitioning is "n" then you use
Command: change system-parameters features
Music/Tone on Hold: music Port: 1c1601
--------------------------------------------------------------------------------
display port 1c1601
                                 PORT INFORMATION

                                     Port: 01C1601

                           Equipment Type: Music On Hold
                           Identification:

display music-sources                                           Page   1 of   7

                   MUSIC SOURCES

      Source No.   Type   Source                           Description

          1:       music  Type: port  01C1601              Main Music

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting
 
Thanks guys.

It was setup for loudspeaker. Didnt think to check that since this site has never had a paging system installed!!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top