I have multiple cubes created from the same model. When I set up a drill through on a measure, and then try it, I see that drill through in every cube. Is there any way to set it so it only shows for a particular cube? will I have to set up the drill through on the cube instead of the measure?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
designating drill throughs
- Thread starter thabrane
- Start date
Similar threads
- Locked
- Question
- Locked
- Question