We have been using the 9.x web client on our workstations and I have been testing the 10x client but have added the PnAgent to the install.
I am having 2 issues.
1 - I was unsuccessful using a GPO to deploy the install so I created a simple VBscript to install it. Should I be able to use a GPO to deploy the msi?
2 - For test group I deployed the PnAgent but missed the Pass thru settings. I recreated the admin point using the /a switch and included all desired settings. Both the original install and the new one were configured to allow updates. When I launch the new install with pass thru enabled the installer starts up but stops on the Repair, Modify, Remove screen. No matter what you try nothing will happen, only cancel works.
If I manually uninstall the older client then run the new install it runs complete unattended as expected.
Any reason why the upgrade is not working?
I am having 2 issues.
1 - I was unsuccessful using a GPO to deploy the install so I created a simple VBscript to install it. Should I be able to use a GPO to deploy the msi?
2 - For test group I deployed the PnAgent but missed the Pass thru settings. I recreated the admin point using the /a switch and included all desired settings. Both the original install and the new one were configured to allow updates. When I launch the new install with pass thru enabled the installer starts up but stops on the Repair, Modify, Remove screen. No matter what you try nothing will happen, only cancel works.
If I manually uninstall the older client then run the new install it runs complete unattended as expected.
Any reason why the upgrade is not working?