I have a Dell Powerconnect 3324 switch, it is running defaults settings, no special configuration. I have enabled SNMP on the switch and I am graphing the traffic with another PC.
To make a long story short, every port on the switch graphs at the same bandwidth. What I'm wondering is there a setting/option somewhere in the switch config to seperate each port, or not have them tied together. Because that's what it seems like.
Please any help is appreciated!
Thanks.
To make a long story short, every port on the switch graphs at the same bandwidth. What I'm wondering is there a setting/option somewhere in the switch config to seperate each port, or not have them tied together. Because that's what it seems like.
Please any help is appreciated!
Thanks.