Definity to IP over analog line & station

[fcepeda]

Hi,:

I have a IPO 403 and Definity R12 without Medpro, and one of my need is transfer call from IPO lines to Definity stations, so I interconnect 2 analog trunk port in the IPO to 2 analog station port in the Definity, I can make the transfer but when both party hang, the analog trunk ports in the IPO used to recive call and transfer to Definity are still connected.

Somebody can help me ¿What is the correct config to do this?

 

[intrigrant]

Do the definity gives a disconnect clear signal on the alog line?
If not then IP Office will continuesly scan the line for a 5 seconds long busy tone and then free up the line.
But if your busy tone is not what IP Office expects then the line will be open infinitely.
You can alter the settings for busy tone detection in the System > telephony section.