I have A Definity G3R with an EPN cabinet that is throwing a POWER alarm. The failures during testing point to the Battery charger and/or batteries. I have replaced both as well as the MAINTENANCE circuit pack TN775B. I have also installed their batteries and charger in our shop and did not get an alarm. I have done a RESET SYSTEM 1 and 2 on their switch and still can not get rid of their alarm. ANy ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Definity G3R release 8
- Thread starter interfac1
- Start date
mikeydidit
IS-IT--Management
I beleive the command is to "test enviroment long clear". If you are not having any errors being logged because of it anymore, See if that will get it for you.
Mike Jones
LSUHSC
Mike Jones
LSUHSC
- Status
Similar threads
- Locked
- Question