Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Default Values in Parameter Not Updating

Status
Not open for further replies.

jsh8286

Technical User
Mar 4, 2010
61
CA
Have created a Crystal Report where the driving table is the ICITMV Vendor Details Table. The Parameter that we have created Browses the "VENDNAME" field. And for our purposes we have included all the fields.

One issue has arisen. Assuming there is a vendor we do not order from anymore we remove all of the items associated with that vendor. So in theory that vendor name should not show up anymore in the Browse list of the parameter but unfortunately it does. The parameter does not "refresh" automatically and the vendor in question is still in the list. Unless we don't include them in the list or if we exclude all the vendors and then reinclude them all in the list and save will the parameter refresh.

So is there a way to make the parameter refresh automatically when the report runs in Sage Accpac?

Hope this makes sense.

 
Simple solution as it turns out. It appears Crystal V10 does not have the capability of a "dynamic" paramter. So went to a later version and re did the parameter as dynamic and all good.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top