Dedicated LD T1 Outage

[rtetryyt]

Can anyone help me out? I have a whole building with no LD. What steps would I take to change my LD to the local PRI until Qwest fixes my LD PRI? I think I am on Communication Manager 2 Thanks TJ

 

[Klees]

You need to change your route patterns can you "li route" and view them? I am not familiar with CM 2 so I may not be the best one to help.

You can change your route patterns for LD to use your local trunks

 

[rtetryyt]

Do you know which item I need to change within each route pattern?

 

[98Converter]

Underneath Grp No. you would want to put in the trunk group# of the Local PRI. You'll need to ensure the bottom section values (if used) are set correctly as well...

DISCLAIMER:This may be not be a recommended change with someone that is not familiar with the changes & their impact.

change route-pattern 1 Page 1 of 3
Pattern Number: 1 Pattern Name:
SCCAN? n Secure SIP? n
Grp FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 3 1 200 1 n user
2: 2 1 200 1 n user
3: 5 1 200 1 n user
4: n user
5: n user
6: n user

BCC VALUE TSC CA-TSC ITC BCIE Service/Feature PARM No. Numbering LAR
0 1 2 M 4 W Request Dgts Format
Subaddress
1: y y y y y n n bothept none
2: y n n n n n n bothept none
3: y y y y y n n rest none
4: y y y y y n n rest none


Thanks,
98C

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[Klees]

Were you able to get this set correctly? I would leave everything as is both groups may very well be set the same, mine are... just change the trunk number listed on the first line in your LD route pattern to the trunk number that is for local calls. then test.