DECT Signal measurement

[george74]

Hello all.
As still dont have the Avaya dect site survey Kit my short question is: Can i measure the base station's signal strength using a 37XX Series dect handset?
Forgive me if im wrong but i remember a type of 37xx series handset had this feature built in.
What do you think?

Regards

 

[tlpeter]

Yes you can with the 3725.


3725 Site Survey Mode
The following method is used to put a subscribed 3725 into site survey mode.
1.Go to the menu Call Time.
2.Activate the Admin menu by pressing * * .
3.In Admin menu, select DECT Info. The phone will display information about the base station.
· C7 S10
This is the DECT signal carrier and slot.
· ss
This is the signal strength. This is the main value that should be recorded and accessed as you perform the
survey.
· Error rate / Q2 Error rate
These are the error (corrupted) frames per second on the signals from and to the base station.
· Park:
The PARK (SARI) of the DECT system.
· PARI
The PARI of the DECT system.
· Bear:
The current power output of the phone.
· Pwr = on hook
· LU = off hook, Low power
· US = off hook, Normal power
· EU = off hook, High power


Homo sapiens non urinat in ventum

honey, i fried the IP Office !!!

Sarcasm, it's only one of the services I offer.

 

[Bas1234]

What IPdect system do you have?

___________________________________________
It works! Now if only I could remember what I did...

Dain Bramaged
___________________________________________