DECT Ethernet Management Connection

[mabsar]

Hi all,

I am having problem with Ethernet Management Connection of DECT system.

DECT system itself is working without any problem as however if I try to connect to the DECT system using OTM I can not get connected but IP address of DECT ethernet card keep on responding to ping command. To connect with DECT I have to reset the card by unpluging the card from slot and insert it again, by doing this I can get connected with DECT using OTM but this situation last of 15 or 20 minutes then I lost the connection again till I reset the card again, which causes intruption to DECT user.

Any idea to solve this problem....

Regards

 

[MossEng]

When you reseat the card it reactivates the default password on the DECT card for a short time for password recovery, So next time you do this change the DECT password
to match the OTM DECT password.

 

[Firebird Scrambler]

I've got the same problem when I upgraded to TM3. I thought it was a TM3 problem. Can you change OTM's Dect password to match the default password on the Dect card?.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://mysite.orange.co.uk/firebird_scrambler

Useful Nortel forum at

http://www.tspforum.com

If it's working, then leave it alone!.

 

[mabsar]

Thanks for your replies.
I am on holidays these days. I will try what u have suggested once I resume after new year and will let you know if there is any improvment.
Thanks once again.