DCT1800

[aau2]

Hi, we have attached one system DCT1800 Ercisson to our MD110, the version of MD110 is BC.9, We have upgraded the freeset system from a/b to GAP. When upgraded the system to GAP we should see the number of the incoming calls in the cordless phone, but it doesn´t work.
What we should change in the configuration of the MD110?. The attachment beetwen the MD110 and the cordless system DCT1800 Ercisson are two CAS Primari (2MB) thwe configuration of the CAs extension are
<sudip:dir=78134;
DIRECTORY INFORMATION AT 07:48:49 09JUN05
DIRECTORY NUMBER : 22156
TYPE OF DIRECTORY NUMBER : CAS
NAME :

EXTENSION TERMINAL DATA
EQU TERMD ADN
1-0-30-10 0001

EXTENSION DIRECTORY CATEGORIES
CAT TRAF SERV CDIV ROC TRM ADC CUST
4 00040415 02021207 000151000 0000 0 010100301

GROUP DATA

DIVERSION DATA

END

Is the configuration ok?. Or have we to upgrade the MD110 to see the incoming call number in the cordless phone?

 

[etompau]

What ICAT do you have on the CAS extensions? (0008)

 

[aau2]

No ICAT=0001,

 

[etompau]

You must use enchanced CAS (CAS+) in order to get A-number presentation in the DECT phones.
Change the ICAT to 0008 for all CAS extensions.

 

[aau2]

I have tried to change it but it didn´t allow it.
<EXCACIR=22156,ICAT=0008;
NOT ACCEPTED
EL7-ICAT CHANGE
NOT ALLOWED
<

 

[whosrdaddy]

you must use EXTEE, EXTEI to achive this. If I remember correctly you must deprogram all extension of the same board and then initiate them with the new icat param

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!

 

[aau2]

Thanks, it works OK. I had to deprogram all extensions and initiate every extensions again.